3D Printing in Space

3D Printing in Space 3D Printing in Space 3D Printing in SpaceBen Campbell is the U.S. representative for this years WorldSkills competition.I like to stay as accelerated as I can, said Benjamin Campbell, a 19-year-old sophomore at Idahos Northwest Nazarene University. Hes doing a pretty good job of that. By one measure, hes the best young mechanical engineer in the country Campbell is the U.S. representative for this years WorldSkills competition, to be held in Kazan, Russia, next month.WorldSkills is the Olympics of trade skills, where students from more than 70 countries compete in solving real-world problems. Campbell had to beat out his U.S. competitors in multiple levels of competitions to make it to Kazan.But rising to this zenith is only one of Campbells accomplishments. Hes also been part of the Northwest Nazarene gruppe that, with NASA, is about to put the first satellite to be 3D printed in space, in space.The satellite, MakerSat-1, is more or less a duplicate of the now o rbiting MakerSat-0. The predecessor, a birdhouse sized cube, had a few samples of plastics for 3D printing to see how well they stand up to the rigors of space. As a freshman, Campbell joined the team that put that satellite in orbit.You May Also Like The Little Rocket Engine That Could MakerSat-1 will be assembled on the International Space Station.The big difference between MakerSat-0 and MakerSat-1 is that MakerSat-1 will be assembled on the International Space Station. In fact, its frame has already been printed. All the hardware is done, all the electronic boards have been debugged and are functioning just fine, Campbell said. The only thing we are waiting on now is to get a launch date.MakerSat-0 needed a metal frame to withstand the forces of a launch. Since MakerSat-1 wont have to face the same G-forces, its lighter and screw-free. The components snap together using little protrusions, like a Lego guys handsclaw shaped, Campbell said. The whole satellite can b e assembled in six minutes.The first satellite also ran into some problems. It began having sudden power drops, most likely from a faulty solar panel. It would charge up till the battery had enough juice to start an experiment and then the battery would die again. So, for MakerSat-1, Campbell and his team built in redundant systems for different power situations. They also used flexible solar panels that have a better chance of withstanding the higher vibrations of a rocket launch.Recommended for You Top 6 Innovations in 3D PrintingWhen Campbell is not working on a slew of projects, hes boning up on all things engineering for the WorldSkills competition in August. Theres a mind-boggling amount of stuff Im learning, he said.Campbell hopes to eventually put that breadth of knowledge to use helping other students launch things in space. GPS used to be mostly for spying on other countries. Now its on your phone showing you where you are in the world anytime you want, he said. One thing that hasnt gotten to that level is people being able to go to or send things to space. I would like to make it more accessible to the public, to make it easier for schools or companies to send things to space.And theres one thing in particular Campbell would like to send there If possible, I would like to go to space myself, he said. I know the selection for that is very narrow, but I would totally do it if I could.Michael Abrams is a technology writer based in Westfield, N.J.